window regulator
Hey there,
1. remove the outer window cover strip.
2. remove the door trim panel
3. remove sound/vapour barrier
4. lower glass until bolts(that hold glass to regulator) are accessible
5. loosen bolts holding glass
6. tilt back of glass up and remove from door
7. pull cable back and detatch it from the inner door handle
8. undo the connector, undo screws and remove the speaker box
9. remove the connector from the window motor
10. pull off the guide
11. undo the top three screws/bolts, loosen the bottom three, and remove the complete cable on the window regulator
FOR INSTALLATION:
1. install the regulator in the locating bracket and install all bolts loosely
2. tighten down the upper left and upper right bolts (as you look at the inside of the door)
3. re-install the window glass and switch, and lift window up, leaving 10 mm gap from the top
4. adjust window gap dimensions: top of glass to window seal/finisher = 10mm and glass diagonal to glass seal/finisher = 5.4mm(seems real specific to me)
5. tighten the clamping jaws for the glass
6. lower the window down to its stop and tighten down the bottom left and bottom right regulator bolts
7. close the window firmly and tighten the 2 remaining bolts (toward the middle of the door)
8. re-install sound/vapour barrier and door trim panel
9. re-install the outer window cover strip
Et voila, there you have it...
Sounds real simple, eh?
Hope these instructions help somewhat,
Tiger
P(ost) S(cript): Good idea to look at the link given by Eugene. Photos do help and i might have missed something